BONDING FIBREGLASS PANELS TO VEHICLES
 
N.B. THOROUGHLY DEGREASE ALL PANELS, AS THERE MAY BE MOULD RELEASE WAX IN PLACES.
 
1. Mark out area of contact and clean vehicle paint down to primer surface using 80 grit paper.
2. Prepare contact surface of fibreglass with 80 grit paper.
3. Dry fit panels to check alignment.
4. Wip with moist cloth of cellulose thinners or acetone both contact surfaces proir to application of bond agent.
5. Mix bond agent and apply sufficient amount to both surfaces.
6. Apply pressure and secure panels, removing any excess bonding agent.
7. When fully cured, smooth in joins with polyester body filler ensuring joins are covered.
8. Shape vehicles with 80 grit paper to start and finish off with 240 grit.
9. Vehicle now ready for paint process (see painting advice).
 
 
 
 
 
Page 9